![]() ![]() Make sure that the end point of the line is on the guide line. Select the line tool and draw the front edge of the roof. Then click with the left mouse button and move the guide line to the center point (blue circle) of the edge. Select the Tape Measure Tool, move the mouse over the z-axis until a red square appears. Select the Rectangular Tool and draw the base surface of the front roof from the coordinate origin. To complete the photo match click with the right mouse button and select "done". Click with the left mouse button and change the scale by moving the mouse. When you hover with your mouse over the z axis, the cursor changes into two little arrows. The z-axis should coincide with a vertical edge of the house.įor adjusting you can use the x- and y-axis handles.Ĭheck the alignment with other edges of the house. To check the alignment, you can drag the origin to another corner of the house. The x- and y-edges of the house must be offset by 90° to the y axis. Now drag the y-axes (green dashed line) on two parallel edges of the building and align them with the green squares at the end of the lines.ĭo the same with the x-axis. ![]() The corner should be visible from both pictures. Pull the yellow square onto a corner of the roof. The red line is the x-axis, green the y-axis and blue the z-axis. ![]() The yellow square is the origin of the coordinates. Navigate to your "Images" folder and select an image. Open the drop down menu "Camera" and select "Match New Photo.". Next we create a folder structure containing our project data.Ĭreate a new folder, rename it and create three subfolders "Models", "Images" and "Exports".ĭrop the pictures into the "Images" folder.Īctivate the used tools by right click the toolbar and select the tools as needed. The pictures should be taken at a 45° angle from two opposite corners. Two Pictures of the building you like to model In this tutorial you will learn how to use photo matching to model your building with SketchUp and use it in PV*SOL premium. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |